PDA

View Full Version : Cold Cure



Daniel
12-08-2001, 09:19 PM
Due to the lack of a steady and reliable heat source in my shop, I am hoping to use Industrial Formulations Cold Cure epoxy. What I dont get from the lit is if you can use this with silica and microspheres to make putty for filleting the joints on a stich & glue. Any feedback would be appreciated.
Thanks

Noah's
12-23-2001, 10:58 PM
Yes, Coldcure can be used with all fillers

Noah's

rjanema
12-26-2001, 10:17 PM
Beside the benefits from using at lower temperatures are there any significant drawbacks from using cold cure? If so what are some of them.

Noah's
12-28-2001, 03:09 PM
Comparing Coldcure to MAS or EAST System epoxy there is 1 drawback, and that is that Coldcure does blush a bit if you're coating wood, or fiberglassing. MAS or EAST (with slow hardeners) do not blush.

Noah's