GNFG
01-01-2016, 02:00 PM
I am about to begin building a low profile sneak/layout boat for duck hunting, using the stitch and glue method.
Most plans that I have seen, call for a plywood core. I would like to try foam board - light and rot-free.
Will the foam board work as the core with a fiberglass/Kevlar skin over it?
Does the board handle the stitches OK?
Should the board be sealed on both sides?
Is there inherent floatation in the foam board?
GNFG
Most plans that I have seen, call for a plywood core. I would like to try foam board - light and rot-free.
Will the foam board work as the core with a fiberglass/Kevlar skin over it?
Does the board handle the stitches OK?
Should the board be sealed on both sides?
Is there inherent floatation in the foam board?
GNFG