PDA

View Full Version : "Redemption" - One Off Custom Contemporary



crosbyboat
01-21-2007, 05:29 PM
I've been working on plans for a super sized outboard 3 point hydroplane. I started contruction this winter. The boat is 16' long with 7' wide sponsons. The boat has a 4' wide tunnel from the sponsons forward, and then a tapering tail to the transom. The boat is being framed with mahogany, and oak. The boat will then be covered in mahogany plywood from Noahs. I'll use a one piece 16' length for the bottom so I wont have to scarf a joint, then 8 footers should handle the rest. Rear frames are done, and the first couple of sponson frames were laid out today and cut. I'll be dropping a 1971 1350SS Mercury (135 hp short shaft) on this. One seater. Wife and kids wont be riding in this one!:D

crosbyboat
01-30-2007, 05:27 AM
A couple of photos showing current framing status. Sponson bottoms and first stringer are in.

Noah's
02-02-2007, 08:51 PM
Nice progress being made there!

keep us updated.

funonwater
01-29-2010, 11:08 PM
Going to build sport hydro need 2 know where to buy wood for frame found plywood allready , also what kind of wood 2 use for frame so much info online gets to be confussing ,maybe u know where to get the best prices seems that ur making good progress on urs .