A "venturi" type of a valve that allows you to generate a vacuum from a positive pressure air line. Less expensive than a vacuum pump.
1/4" NPT Thread Fittings (female) with barbed fitting attachment
Multi-purpose vacuum bag sealant tape that will seal easily to our vacuum bags and your mold. Clean up is simple. 1/16" x 3/8" x 50 ft. per roll (1.6mm x 9.5mm x 15.4m)
High tack sealant tape that is wider and thicker than our AT-199. Excellent clean up. Roll size is 1/8" x 1/2" x 25 ft. (3.2mm x 12.7mm x 7.62m)
Nylon film, resistant to polyesters, epoxies and vinylester with excellent elongation and strength for contours. .0015 x 60" x 1000 ft.
A heavier version of our Econo Ply J, used when extra strength is needed for removal. An excellent texture to the laminate surface is acheived, avoiding sanding/abraiding as a surface prep. 60"x 250 yd/roll
A tight weave all white polyester peel ply to texture the laminate surface, avoiding sanding or abraiding as a surface prep for painting or bonding. 60" x 100 yards
An open weave nylon peel ply with a red tracer, untreated, to texture laminate surface avoiding sanding or abraiding as a surface prep for painting or bonding. 60" x 25 yards
Lightweight breather that allows you to pull "full" vacuum and remove volatiles without vacuum trap off that can warp laminates. 60" x 100 yards
Efficiently distributes resin with little waste due to the low profile, tight construction. 41” x 350 ft
This release film provides excellent release from polyesters, vinylesters, and epoxies. 285°F (140°C) Good elongation and conformability. .001" x 60" x 1000 ft
This perforated release film provides excellent release from polyesters, vinylesters, and epoxies. 285°F (140°C) The small hole perforations allow for bleeding and breathing. .001" x 60" x 1000 ft
SafeleaseŽ 30 is a non-silicone waterbased PTFE release liquid. It will release any laminate from any type of mold surface and will withstand temperatures up to 450° F(232° C).
Designed to provide accurate, controlled vacuum that you can see and adjust. 1/4" NPT fittings
A negative pressure gauge that allows you to see how much vacuum pressure is actually on your laminate and if your vacuum bag is sealed or leaking. 1/4" NPT Thread Fitting (male)
A "through the vacuum bag" connector that allows you to easily pull vacuum. Work jointly with our AQD 500 quick disconnect. 1/4" NPT Thread Fitting (male)
