used to connect polyethylene tubing and/or spiral wrap together, to make your network of vacuum infusion lines to the laminate. "Barbed" ends enable a secure union with only a press fit. Available in "T's", 90 degree elbows, and straight couplings of various sizes.
airtech's omega flow lines are for use under the bag in single and double bag resin infusion aplications, replacing spiral wrap polyurethane feeder lines. Omega flow lines incorporate an "omega section" internally to transport resin along the surface and into the part. Omega flow lines are made from translucent silicone ...
AirTech Spiral Wrap air duct infusion hose is used to allow air, and eventually excess resin, to be pulled from the perimeter of a molded product. This stiff plastic tubing is strong enough not to crush under any normal vacumm bagging pressure and allows proper flow of air and resin to get an even coat throughout the part being
Polyethylene Tubing is used to connect the vacuum reservoir to the part to be infused. Available with a 1/2" O.D. and a 3/8" I.D. for use with 3/8" fittings or a 5/8" O.D. and a 1/2" I.D. for use with 1/2" fittings.
Vacuum Reservoir RB 451 is designed to collect excess resin during the infusion process and prevent damage to your vacuum pump. 2.5 gallon tank size, comes complete with polyethylene liner, vacuum regulator/gage, quick disconnect coupling, and two barbed fittings for 5/8" and 3/4" I.D. hose.
This release film provides excellent release from polyesters, vinylesters, and epoxies. 285°F (140°C) Good elongation and conformability. .001" x 60" x 1000 ft
<p><font color="#ff0000">* Please Note: <span style="mso-ansi-language: EN-CA" lang="EN-CA">Our shipping calculator recognizes fiberglass, vacuum bagging
This perforated release film provides excellent release from polyesters, vinylesters, and epoxies. 285°F (140°C) The small hole perforations allow for bleeding and breathing. .001" x 60" x 1000 ft
<p><font color="#ff0000">* Please Note: <span style="mso-ansi-language: EN-CA" lang="EN-CA">Our ...
<p>Resinflow 60 is designed to assist resin flow through your part during the VARTM (Vacuum Assisted Resin Transfer Moulding) process. Our resin distribution medium works well with polyester, vinylester and epoxy resins.<br />Resin flows more easily throughout your lay-up, when using Resinflow 60.<br /></p> <p><font ...
inexpensive polyethylene parts, used to connect the vacuum manifold and resin feed lines for low temperature resin infusion projects. RIC 12 is used with a 1/2" O.D. tubing and the RIC 58 is used with 5/8" O.D. tubing.
Stretchlon 200 is green in color with a 250° F maximum temperature usage.
Stretchlon 200 is ideal because it is able to stretch to compress every area of the mold. This high elongation vacuum bagging film is rated for temperatures up to 250°F and can stretch to 500% of its original length. Unlike traditional bagging film, ...
Designed to provide accurate, controlled vacuum that you can see and adjust. 1/4" NPT fittings
A negative pressure gauge that allows you to see how much vacuum pressure is actually on your laminate and if your vacuum bag is sealed or leaking. 1/4" NPT Thread Fitting (male)
A "through the vacuum bag" connector that allows you to easily pull vacuum. Work jointly with our AQD 500 quick disconnect. 1/4" NPT Thread Fitting (male)