Flow Media

Enkachannel for resin infusion

Enka-Channel is a 100 mm wide, 4 mm thick, supply or feeder channel for VARTM, consisting of a black three-dimensional polyester filament core structure wrapped in a white polyester filter. May be used in the production process of ...

Enkachannel for resin infusion

Enka-Channel is a 50 mm wide, 4 mm thick, supply or feeder channel for VARTM, consisting of a black three-dimensional polyester filament core structure wrapped in a white polyester filter. May be used in the production process of ...

Efficiently distributes resin with little waste due to the low profile, tight construction. 41” x 350 ft

used to connect polyethylene tubing and/or spiral wrap together, to make your network of vacuum infusion lines to the laminate. "Barbed" ends enable a secure union with only a press fit. Available in "T's", 90 degree elbows, and straight couplings of various sizes.

used to connect polyethylene tubing and/or spiral wrap together, to make your network of vacuum infusion lines to the laminate. "Barbed" ends enable a secure union with only a press fit. Available in "T's", 90 degree elbows, and straight couplings of various sizes.

used to connect polyethylene tubing and/or spiral wrap together, to make your network of vacuum infusion lines to the laminate. "Barbed" ends enable a secure union with only a press fit. Available in "T's", 90 degree elbows, and straight couplings of various sizes.

airtech's omega flow lines are for use under the bag in single and double bag resin infusion aplications, replacing spiral wrap polyurethane feeder lines. Omega flow lines incorporate an "omega section" internally to transport resin along the surface and into the part. Omega flow lines are made from translucent silicone ...

AirTech Spiral Wrap air duct infusion hose is used to allow air, and eventually excess resin, to be pulled from the perimeter of a molded product. This stiff plastic tubing is strong enough not to crush under any normal vacumm bagging pressure and allows proper flow of air and resin to get an even coat throughout the part being

Polyethylene Tubing is used to connect the vacuum reservoir to the part to be infused. Available with a 1/2" O.D. and a 3/8" I.D. for use with 3/8" fittings or a 5/8" O.D. and a 1/2" I.D. for use with 1/2" fittings.

Resinflow 60 is designed to assist resin flow through your part during the VARTM (Vacuum Assisted Resin Transfer Moulding) process. Our resin distribution medium works well with polyester, vinylester and epoxy resins.
Resin flows more easily throughout your lay-up, when using Resinflow 60.