Items

used to connect polyethylene tubing and/or spiral wrap together, to make your network of vacuum infusion lines to the laminate. "Barbed" ends enable a secure union with only a press fit. Available in "T's", 90 degree elbows, and straight couplings of various sizes.

used to connect polyethylene tubing and/or spiral wrap together, to make your network of vacuum infusion lines to the laminate. "Barbed" ends enable a secure union with only a press fit. Available in "T's", 90 degree elbows, and straight couplings of various sizes.

used to connect polyethylene tubing and/or spiral wrap together, to make your network of vacuum infusion lines to the laminate. "Barbed" ends enable a secure union with only a press fit. Available in "T's", 90 degree elbows, and straight couplings of various sizes.

AirTech Spiral Wrap air duct infusion hose is used to allow air, and eventually excess resin, to be pulled from the perimeter of a molded product. This stiff plastic tubing is strong enough not to crush under any normal vacumm bagging pressure and allows proper flow of air and resin to get an even coat throughout the part being

Polyethylene Tubing is used to connect the vacuum reservoir to the part to be infused. Available with a 1/2" O.D. and a 3/8" I.D. for use with 3/8" fittings or a 5/8" O.D. and a 1/2" I.D. for use with 1/2" fittings.

<p>Resinflow 60 is designed to assist resin flow through your part during the VARTM (Vacuum Assisted Resin Transfer Moulding) process. Our resin distribution medium works well with polyester, vinylester and epoxy resins.<br />Resin flows more easily throughout your lay-up, when using Resinflow 60.<br /></p> <p><font ...