Unwaxed medium gel general purpose marine grade laminating resin for wet layup. Low viscosity wets all types of fibreglass fabric well with minimal drain on vertical surfaces. Unwaxed resin is air-inhibited and will stay tacky on the surface when cured, allowing for extra laminating or bonding without further prep or sanding up to 24 hrs. After 24 hrs it may be necessary to sand for optimum bond particularly if exposed to sunlight or dust. Catalyse with MEKP at 1.25% to 2% between 65F/18C and 90F/32C, do not use below 50F/10C. Always do a test batch to determine correct MEKP ratio as temperature, humidity and volume will change pot life and gel time.
Waxed medium gel general purpose marine grade laminating resin for wet layup. Low viscosity wets all types of fibreglass fabric well with minimal drain on vertical surfaces. Waxed resin is used as a final coat when sanding is required. Always sand and wipe down with acetone if applying a new coat of resin or gelcoat over waxed resin. Catalyse with MEKP at 1.25% to 2% between 65F/18C and 90F/32C, do not use below 50F/10C. Always do a test batch to determine correct MEKP ratio as temperature, humidity and volume will change pot life and gel time.