Hello and welcome to our community! Is this your first visit?
Register
Results 1 to 2 of 2
  1. #1
    Join Date
    Feb 2004
    Location
    Buffalo NY USA
    Posts
    3

    laminating a hatch

    Hello,

    I am preparing to make a replacement companionway hatch for a Hinterhoeller HR25. The original was half inch plywood with thin teak decking on top. Overall size is about 30 inches wide by about 45 inches fore and aft. I expect to laminate 4 layers of eighth inch plywood with epoxy to reproduce the main structure, and then decide whether to attempt recovering the old teak decking, etc.

    My question is about jigging and clamping. I was thinking that the following would work:

    1. Determine the set-up camber, so that the finished unit is about the same as the original after spring-back.

    2. Make a male form from three eighths plywood, propped with a piece of 2-by stock in the center to get the right camber, and cover it with poly for a release film.

    3. Fasten the first eighth inch ply over the jig on each edge with a batten and screws, and roll on the epoxy.

    4. Wet out the underside of the second ply.

    5. Lay down the second ply and fasten on one edge, then roll it out to reduce air pockets, and fasten the other edge.

    6. Continue for the rest of the plies.

    7. Lay down a poly-covered three eighths plywood top to the jig and clamp the entire unit on each edge, then allow the epoxy to set.

    Will this technique work out OK, or will I experience a lot of voids, etc? Do you have a preferred method? I was thinking of alternating grain directions, and possibly laying the center two plies on the bias, at about 45 degrees to the top and bottom plies, yet at right angles to each other.

    Thoughts? Do you recommend any particular epoxy (west, east, etc.)? Will I need athwartships bracing across the top and bottom jig panels to get enough uniform compression?

    Paul Van Voorhees
    Buffalo, NY

  2. #2
    Join Date
    Mar 2001
    Posts
    399
    Sounds like a good plot. You might try 2 layers of ?? just to simplify things. Four layers would be more likely to result in voids. Any epoxy will work, just add a little cabosil to give it some body.


 

Similar Threads

  1. laminating a companionway hatch
    By PVanV in forum Requests & Suggestions
    Replies: 0
    Last Post: 02-03-2004, 01:32 PM
  2. laminating a hatch
    By PVanV in forum Composite Boatbuilding
    Replies: 0
    Last Post: 02-03-2004, 07:03 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •